Cut Studio Reinstall
To reinstall CutStudio follow this link to download the installer
Once downloaded, extract the compressed folder.
After the file has been extracted open the file and go to CutStudio Software and Driver folder.
Be sure to follow the order of installations below to avoid issues.
- Open Roland GS-24_CAMM-1Driver_Windows10_x64_v150 and run the SETUP64 application.
- Go back into CutStudio Software and Driver then into Cutstudio_V201_Installer and run the Setup application.
- Go back into CutStudio Software and Driver then into CutStudio_Updater_V310 and run the CutStudio V310 Updater application.
Related Articles
Switching to V-Bond Inks on Roland UV Printers
V-Bond Ink is Rolands new line of inks that are more environmentally friendly and safer to handle then past inks. Attached is a guide on switching over to these inks on the LEF2 series UV printers. Most important in the guide is being at the latest ...Roland SG3-300/540 Tray Cleaning
This guide will have you follow steps to run a tray cleaning on your SG3-330/540. Run this process if your printer is requesting you run a tray cleaning.Roland TrueVis VG/SG Series Printers "Head Protection Activated" Message
Head Protection Activated. We recently noticed that some of our customers are getting "HEAD PROTECTION ACTIVATED" error message on Roland TrueVis VG/SG print/cut series. Official Roland documentation states that the error might occur in cases when ...Bambu Studio Quick Start Guide
Introduction Bambu Studio is the software used to prepare 3D models for printing on Bambu Lab printers. Before a model can be printed, it must be imported, positioned, configured, sliced, and sent to the printer. This guide covers the most commonly ...LEF Head wash
Click here for a video showing how to enter service mode. This video shows the process on an Roland SG/VG Printer cutter, but the button sequence is very similar for the LEF/LEF2 systems. Written instructions for entering service mode are also listed ...