LEF Head wash

Click here for a video showing how to enter service mode. This video shows the process on an Roland SG/VG Printer cutter, but the button sequence is very similar for the LEF/LEF2 systems. 

Written instructions for entering service mode are also listed below.

• Related Articles

• SG-Series Head Wash

  Click here for a video showing how to enter service mode. Written instructions are also listed below.

• Switching to V-Bond Inks on Roland UV Printers

  V-Bond Ink is Rolands new line of inks that are more environmentally friendly and safer to handle then past inks. Attached is a guide on switching over to these inks on the LEF2 series UV printers. Most important in the guide is being at the latest ...

• Roland TrueVis VG/SG Series Printers "Head Protection Activated" Message

  Head Protection Activated. We recently noticed that some of our customers are getting "HEAD PROTECTION ACTIVATED" error message on Roland TrueVis VG/SG print/cut series. Official Roland documentation states that the error might occur in cases when ...

• Check head board LED's for error 14,133

  There are many possible causes for this error code, but one place to start is the LED's on the head board.  After the printer initializes, check if both or one or the other is lit: 

• Roland SG3-300/540 Tray Cleaning

  This guide will have you follow steps to run a tray cleaning on your SG3-330/540. Run this process if your printer is requesting you run a tray cleaning.