Check head board LED's for error 14,133

There are many possible causes for this error code, but one place to start is the LED's on the head board.  After the printer initializes, check if both or one or the other is lit: 

• Related Articles

• Roland TrueVis VG/SG Series Printers "Head Protection Activated" Message

  Head Protection Activated. We recently noticed that some of our customers are getting "HEAD PROTECTION ACTIVATED" error message on Roland TrueVis VG/SG print/cut series. Official Roland documentation states that the error might occur in cases when ...

• Internal Error Message on Printer in GrabCAD Print

  If you open GrabCAD Print and attempt to connect to your printer but see a message that says Internal Error, the quick fix is to simply delete the printer out of GrabCAD Print and add it back. The message will look similar to below. This generally ...

• LEF Head wash

  Click here for a video showing how to enter service mode. This video shows the process on an Roland SG/VG Printer cutter, but the button sequence is very similar for the LEF/LEF2 systems. Written instructions for entering service mode are also listed ...

• SG-Series Head Wash

  Click here for a video showing how to enter service mode. Written instructions are also listed below.

• Connecting Monitor to uPrint Single Board Computer (SBC)

  This is the process to connect a monitor to the Single Board Computer (SBC) on the uPrint series. This is done to troubleshoot suspected hard drive issues or failure. Step 1 - When power is restored the uPrint starts up, the lights and fans inside ...