F123 maintenance videos

F123 maintenance videos

 

 

https://www.youtube.com/watch?v=8ZL2A7iG7BI print head replacement

https://www.youtube.com/watch?v=WiAj2sBzqhw  Prepare the filament to load.

https://www.youtube.com/watch?v=LetdY48O0B8  How to load material

https://www.youtube.com/watch?v=BUKKEP-lFe4  How to unload material

https://www.youtube.com/watch?v=XoRJdHTEclo  How to trouble shoot a loading issue

https://www.youtube.com/watch?v=H2TqhZ2pFOA  How to replace a material tray


    • Related Articles

    • Manually Leveling the Build Plate on a MakerBot Replicator+

      MakerBot Replicator+ systems are factory leveled, so in most cases you do not need to level them, however we have seen instances where they arrive out of level due to rough handling during shipping. The technique below and the attached files will ...

    • Roland TrueVis VG/SG Series Printers "Head Protection Activated" Message

      Head Protection Activated. We recently noticed that some of our customers are getting "HEAD PROTECTION ACTIVATED" error message on Roland TrueVis VG/SG print/cut series. Official Roland documentation states that the error might occur in cases when ...

    • Force Unload Process For F123 3D Printer

      In some cases, you may be directed by our technicians to perform a 'force unload' procedure in your material bays of your F Series 3D printer. This process resets some values in the firmware that may be causing printing problems. To perform this ...

    • Material Bay Drive Motor Issue - Filament Obstruction

      When you are having trouble loading materials and the drive motor on the material bay does not engage when you place the spool into the material bay, the first thing you should check is your materials screen. With the spool and filament unloaded and ...

    • Roland SG3-300/540 Tray Cleaning

      This guide will have you follow steps to run a tray cleaning on your SG3-330/540. Run this process if your printer is requesting you run a tray cleaning.