Reseating the Material Bay cables on an F170/F270/F370
Reseating the Material Bay cables on an F170/F270/F370
This video shows you how to get easier access to the material bay cables on the Stratasys F170/F270/F370 in the event Stratasys tech support suggests they be reseated:
In order to exchange or return your cartridge or print engine, please fill out this form and email it to RMA@stratasys.com. Do not return a product without authorization from Stratasys.
When you are having trouble loading materials and the drive motor on the material bay does not engage when you place the spool into the material bay, the first thing you should check is your materials screen. With the spool and filament unloaded and ...
A mounting bracket screw may contact and cause problems with components of the F123 Series front interface board. Remove and discard this mounting bracket screw. Click any picture below to see it full size. To perform this procedure you will need: ...
First, remove the screws circled in red: Next, very carefully separate the housing. The components are loose inside the housing, so ensure the blue part of the housing is facing up when you separate them. Refer to the image below for how to put ...
In the event you need to access the laser tube in the back of your desktop laser system (to reseat or replace it), follow these instructions: 1 - Power down the system. This step is critical. If you disconnect the laser tube while power is on it will ...