Universal Laser Systems VLS 3.50 Template - Adobe Illustrator CC

Universal Laser VLS 3.50/VLS 3.60DT Adobe Illustrator CC Template

Attached is a template for the Universal Laser System VLS 3.50. This template can easily be changed for other systems by changing the page size.

    • Related Articles

    • How to exercise the laser tube in a Universal Laser

      The laser tube in a Universal Laser will degrade over time if not used regularly, shortening its life. It's recommended to run or "exercise" your laser during periods of downtime to prevent this from happening. This procedure can also sometimes work ...

    • Performing a USB Reset on a Universal Laser System

      Sometimes windows creates issues with how it communicates with USB ports.  When this happens, you will often see your Universal Laser acting strange.  Usually, all the functions work properly.  You can send a job to the printer, you can change the ...

    • Checking the fuses on a Universal Laser System

      To check the fuses on the laser system, follow these steps: 1. Locate the fuse location behind the machine. They are directly below the power inlet: 2. Press in on both sides of the fuse holder and pull the fuse holder out: 3. Get your multimeter out ...

    • Accessing the Laser Tube on a VLS Desktop

      In the event you need to access the laser tube in the back of your desktop laser system (to reseat or replace it), follow these instructions: 1 - Power down the system. This step is critical. If you disconnect the laser tube while power is on it will ...

    • Laser Beam Alignment for Universal Laser Systems VLS Platform Lasers

      This article will walk you through how to check and align the laser beam in a VLS Platform laser cutter.  NOTE: Make sure the table is clear of any objects that could obstruct the movement of the motion system.   1. Power ON the VLS and let it home ...