GrabCAD - Update Firmware

In GrabCAD first select the printer: 

 

Then go to Settings: 

If the printer firmware is out of date, it will look like this: 

Click on the orange banner.  Then you will see this:  

It may take a minute for this orange button to become available, click on it, then go to the printer and select Maintenance / Update Software:  

After that the printer will show that the update is Verifying and then Updating.  This can take up to 15 minutes. 

• Related Articles

• Updating Job Manager / Firmware on a J35 or J55 via USB Stick

  The video below will show you how to update the Job Manager version on your J35 or J55 via USB Stick

• Ultimaker 6.1 Firmware Update Instructions

  Firmware instructions attached

• Updating F123 Firmware via USB

  1- Click here to download the firmware update - As of June 2024 the latest version is 2.7 Build 5984. Release notes are attached to this KB article. 2- Put the .upg file on a USB drive 3- Plug the USB drive into the front of the printer 4 - Go to the ...

• GrabCAD - Get configuration file

  In GrabCAD select the printer in the bottom right of the workspace:  Then go to Settings and click on Export printer configuration. Save the file and send back to us. 

• Internal Error Message on Printer in GrabCAD Print

  If you open GrabCAD Print and attempt to connect to your printer but see a message that says Internal Error, the quick fix is to simply delete the printer out of GrabCAD Print and add it back. The message will look similar to below. This generally ...