Removing Top Door and Glass Panel From a Platform Laser

• Related Articles

• Laser Beam Alignment for Universal Laser Systems VLS Platform Lasers

  This article will walk you through how to check and align the laser beam in a VLS Platform laser cutter.  NOTE: Make sure the table is clear of any objects that could obstruct the movement of the motion system.   1. Power ON the VLS and let it home ...

• How to exercise the laser tube in a Universal Laser

  The laser tube in a Universal Laser will degrade over time if not used regularly, shortening its life. It's recommended to run or "exercise" your laser during periods of downtime to prevent this from happening. This procedure can also sometimes work ...

• Performing a USB Reset on a Universal Laser System

  Sometimes windows creates issues with how it communicates with USB ports.  When this happens, you will often see your Universal Laser acting strange.  Usually, all the functions work properly.  You can send a job to the printer, you can change the ...

• Universal Laser VLS 3.50/VLS 3.60DT Adobe Illustrator CC Template

  Attached is a template for the Universal Laser System VLS 3.50. This template can easily be changed for other systems by changing the page size.

• Accessing the Laser Tube on a VLS Desktop

  In the event you need to access the laser tube in the back of your desktop laser system (to reseat or replace it), follow these instructions: 1 - Power down the system. This step is critical. If you disconnect the laser tube while power is on it will ...