PDF of Materials not to cut.
See attachment.
Related Articles
How to exercise the laser tube in a Universal Laser
The laser tube in a Universal Laser will degrade over time if not used regularly, shortening its life. It's recommended to run or "exercise" your laser during periods of downtime to prevent this from happening. This procedure can also sometimes work ...
Universal Laser System is not cutting or engraving properly
Here are some of the most common causes of degradation of laser cut and engraving quality: Check the optics: While most users know to check the lens, issues with any of the mirrors or the beam window will reduce quality. Inspect the lens, the mirror ...
Cutting Polycarbonate
During the laser processing of this polycarbonate, the effluent stream produced is composed of small amounts of benzene, toluene, phenol and smaller hydrocarbon fragments such as methane, ethane, ethene, and propene. Additionally, from the carbonate ...
Accessing the Laser Tube on a VLS Desktop
In the event you need to access the laser tube in the back of your desktop laser system (to reseat or replace it), follow these instructions: 1 - Power down the system. This step is critical. If you disconnect the laser tube while power is on it will ...
Performing a USB Reset on a Universal Laser System
Sometimes windows creates issues with how it communicates with USB ports. When this happens, you will often see your Universal Laser acting strange. Usually, all the functions work properly. You can send a job to the printer, you can change the ...