BN-20 Head Wash

This Article will show the process to run a head wash on your Roland BN-20.

First open BN-20 utility while connected the the BN-20

This is located in the task bar.

Next go to options and select head wash.

Finally ensure you have the correct supplies. Cleaning cartridges and dummy foam cartridges.

Select next and follow the prompts on the screen to pump the cleaning fluid through your system.

Once completed you can safely turn the BN-20 off and store it away.

• Related Articles

• SG3/VG3 Head Wash

  Tis Article willl bring you through the process of washing the heads of the SG3 and VG3 for long term storage. Coming Soon.

• Roland LEF UV Printer Key Reminders

  i. Set Print area: Hold setup until it blinks, then when the screen says setup media, press setup once 1. Height – Place object on table (as square as possible, use holes for guidance). Move table back until object is under rear height sensor bar. ...

• Roland SG2 Series Key Reminders

  Refer to the other email regarding maintenance procedures.  It is very important to adhere to the weekly maintenance schedule. Manual Cleaning maintenance procedure - https://www.youtube.com/watch?v=Nw1JNuzjyMo The user guide can be found ...

• Roland BN2-20 / BN2-20A Installation Follow Up

  MOST IMPORTANT DETAIL FROM TRAINING: The printer should always stay plugged in with the main power turned on. The sub power can be turned off, but the main power must remain of for it to continue its automatic maintenance cycles. If this gets turned ...

• VXElements Licensing Guide

  Head over to Creaform's website at: https://cp.creaform3d.com Please follow this guide to create your Creaform account and download your software, licenses, and calibration files: ...